LED blink codes are only used during the first start or firmware updates.
During normal operation, messages and errors are shown on-screen.
| Blink sequence |
Meaning | Details |
|---|---|---|
| RED RED RED | Your kit's firmware isn't programmed or corrupt. No valid firmware file was found on the SD card. | The USB DFU mode is enabled in case rescue is needed. |
| RED RED YELLOW | The firmware file couldn't be opened. Make sure that the firmware file name is correct. If the error persists, try formatting the SD card again or try another SD card. | A file access error occured. |
| RED YELLOW RED | The firmware file is corrupt. Download it and copy it to the SD card again. If the error persists, try another SD card. | File format checks failed. |
| RED YELLOW YELLOW | The loader's memory couldn't be erased. Check your power supply. | Hardware fault. |
| YELLOW RED RED | The loader's memory couldn't be programmed. Check your power supply. | Hardware fault. |
| YELLOW RED YELLOW | The firmware file couldn't be opened. Make sure that the firmware file name is correct. If the error persists, try formatting the SD card again or try another SD card. | A file access error occured. |
| YELLOW YELLOW RED | During firmware update, programming verification failed. Try repeating the update process again. | |
| YELLOW YELLOW YELLOW | Your console's BIOS version was not recognized. | |
| GREEN GREEN GREEN | Firmware update success ! | |
| BLUE | Programming operation ongoing, don't remove the SD card or turn off the console. |